Your Virtual Facility - Specifications as Shown
Design Specifications
Building Code: Current Indiana Requirements
Wind Load : 85 mph
Seismic Zone : 2
Building Specifications - Manufacturing Area
Framing: Gable, Interior Columns
Width: 200’
Length: 250’
Eave: 28’
Roof Cover: 24 ga. Standing Seam Roof
Wall Cover: 26 ga. Exterior Wall Panel w/ Kynar 500 Finish
Trim: Alum. Gutters and Downspouts
Insulation: 6” Fiberglass Batt –Roof, 4” Fiberglass Batt –Walls
Accessories: 2 Loading Docks, w/ Overhead Doors,Manual, Insulated
Roofing Insulation and Ceilings
New Gutters and Downspouts
4” Wall Insulation , 6” Ceiling Insulation
Interior Walls Separating Manufacturing Area From Office Area
Foundation Perimeter Insulated With 2” Rigid Insulation
Area Above Ceilings to be Insulated with 6” Batt
Acoustical Ceilings in Office Areas
2x4 Standard Lay-in Tiles and Grid
Ceilings in Pre-Engineered Building to be Exposed
24ga . Standing Seam Roof, 20yr. Warranty
Exterior Doors:
Qty.(4) 3070 Steel Insulated w/ Locksets
Qty. (2) Overhead Doors , 8x8, Manual Insulated Steel
Interior:
Concrete -Furnish and Install all Required Concrete Work
6” Thick , 4,000psi, Wire Reinforced Slab in Manufacturing Area ,4” in Office Area
Equipment Pads as Negotiated
Flooring- Sealed Concrete in Manufacturing Area, Vinyl Floor and Carpet in Office Area
Painting - Painted, Gypsum Board Interior Partitions in Office Area
Interior of Manufacturing Area to be Painted and Exposed
Plumbing/ HVAC:
ADA Approved Fixtures
Water Heater, Mop Sink,Hose Bibbs
HVAC –25 Tons Office Area
Ductwork,Economizer,Fresh Air Exhaust
1 Exhaust Fan in Each Restroom
All Gas Piping
Unit Heaters in Manufacturing Area
Electrical:
New Underground 3-Phase Service, Size to be Determined
Lighting -400w Metal Halide in Manufacturing Area,
2 x 4 Recessed Florescent Fixtures in Office Area
Exit and Emergency Lights
Switches and Receptacles Per Code
Wiring to HVAC Equipment
Electric Service for Specific Equipment Not Included
Offices:
Interior Partitions
Exterior Walls to Have 8’ Liner Panel on Interior, Gyp. Board. In Office Area
Interior Partitions to Be 3 5/8” Steel Studs w/ Fire Rated Gyp. Board
Wall Separating Office From Manufacturing to Be Two Hour Fire Rated
Interior Doors To be Flush Wood ,Knock Down Frames, Includes All Hardware
Project Costs:
Building: $ 1,826,000
Site Improvements: $ 150,000
Land Costs: 10ac $ 100,000
TOTAL: $ 2,076,000
Completion Time
Construction plans can be completed within 30 days,upon final approval of design
Permits, approvals - 30 days
Construction can be complete in
180-210 days, weather dependent
Back to Top
